VANETs

Vehicular AdHoc Networks

Simulation halts with message "creating sumo pipes"?
Both Python and pywin32 are required for VANET simulations to happen successfully. This is essential for interfacing NetSim with SUMO which is a python base...
Thu, 28 Jun, 2018 at 12:24 AM
Unable to open SUMO Config file in NetSim via New->VANET
This happens if VANET simulations are run as 'Non Admin' users. It is always necessary to run VANET simulations in Admin mode, preferably unde...
Wed, 4 Jul, 2018 at 3:57 PM
How to perform VANET Simulations in NetSim over map view?
NetSim map view supports OpenStreetMaps which provides free editable maps of the world. Road traffic conditions can be modeled conveniently in Simulation of...
Mon, 9 Jul, 2018 at 2:43 PM
Please explain the steps involved in interfacing SUMO with NetSim
Installation Admin Privileges is required to install NetSim. SUMO will install along with NetSim. The general installation paths would be Python: C:\Pyth...
Sat, 2 Jun, 2018 at 5:52 PM
In VANET simulations, why are the coordinates and alignment of the roads different in SUMO and NetSim?
The origin (0,0) is located at the top left in NetSim whereas in SUMO it is in the bottom left. Due to this, the SUMO network will be shown inverted in NetS...
Thu, 5 Apr, 2018 at 11:45 AM
How to convert NS2 Movements file to NetSim Mobility file format?
VANET simulators such as SUMO can output the mobility file per the ns2movements file format. The steps below explain how to make a ns2movements.tcl file com...
Sat, 14 Apr, 2018 at 4:07 PM
How to include traffic signals over NetSim-SUMO network in VANET simulations over map view?
Solution 1: Traffic signals will automatically get imported if the map region(map.osm) that you are exporting from openstreetmaps contains traffic signa...
Mon, 9 Apr, 2018 at 6:25 PM
Explain some basics of running VANET Simulations in NetSim?
1. How do I set the frequency of data transmission? Like 20 / 30 messages per second?     Traffic in NetSim is configured using the Application icon. The f...
Tue, 5 Jun, 2018 at 10:46 AM
How to use SUMO NetEdit utility and randomtrips.py to configure road traffic models?
Netedit is a Road network editor for the road traffic simulation in SUMO. Using this utility users can quickly design road networks and obtain Network xml f...
Fri, 10 Aug, 2018 at 10:30 AM
How to open OpenStreetMap based SUMO configuration in NetSim via New->VANET?
Attempting to open an OSM based SUMO configuration in NetSim directly via New->VANET, is not the correct method of performing VANET Simulations over mapv...
Mon, 18 Jun, 2018 at 8:46 AM