Applicable VersionsNetSim AcademicNetSim StandardNetSim Pro


Applicable Releases
v13.3


  1. User modified parameters will not reflect in newly dropped devices: After dropping nodes on the environment, modification of protocols/ global properties (like Physical Layer parameters, Data Link Layer parameters, and others) in one node will reflect in all other nodes. However, after modification, if any new node is dropped, the modifications will not reflect in the newly dropped nodes.  
    • Solution: After dropping new nodes, open the properties of any previously dropped wireless node and click accept
  2. Device real IP & Destination real IP validation is not perfect in Unicast, Multicast & Broadcast emulation.
  3. The packet size limit in TDMA (Military Radio): High packet sizes will lead to zero throughputs.  Max Packet Size = (Time_Slot_Block_Size*Slot_Duration*Data_Rate) / 8 where SLOT_DURATION is in millisecond and DATA_RATE = 25kbps.
  4. Antivirus software may identify NetSimSimulation.exe as malicious and block or remove it from the NetSim install directory. Exceptions will have to be added to avoid this.
  5. Up-link Speed and Downlink Speed are independent parameters and need to be configured individually.
  6. If Zigbee and WLAN are configured together in the same network, then the animation for the battery model does not work correctly and may lead to unexpected behavior.
  7. DSR is not designed to work with ICMP, VLAN, etc. Hence users cannot set ICMP, VLAN, etc when running simulations involving MANETs connected to wired networks.
  8.  Animation over map view requires the user to do.  
    • A single click on the map to load the devices.
    • The map loads India by default. The user will have to move the map to the location where devices were placed.
    • Wireless node movement may not be accurate.
  9. Bridge nodes in MANET do not support ZRP and OLSR protocols.  
  10. Zero throughput for Point to point and serial connection scenario in TDMA Radio Network
  11. In any network, zoom then create any scenario and run simulation the scroll bar is disappearing.
  12. In an IoT network, if packet capture is enabled in a destination node that receives packets from a sensor via the 6LoWPAN Gateway and Router, the source IP address is invalid. It is usually similar to "0.0.0.x" Eg: 0.0.0.78
  13. Rate adaptation Minstrel data table is not writing in metrics window For IEEE 802.11 ac with n, ac with ac, n with ac & n with n.
  14. In IoT if the application is In-between Sensor and Wireless node, displaying the error as "Animation is not yet started. So, function call animation_add_new_entry is not valid" and in animation window no battery power for the sensor.
  15. Create a scenario in Mobile Adhoc Network with multiple manet and Bridge nodes, if we enable ICMP in all devices with DSR routing protocol, the Scenario is crashing.
  16. The RIP routing protocol is not working when 5 routers are considered.
  17. Antivirus issue
    • Norton and K7 Total security are blocking NetSim.exe, NetSim Setup, Uninst.exe
    • Trend Micro detecting simulation.exe, uninstall.exe
    • Avast is blocking Checksum.txt while creating the default workspace it won't allow to create a workspace.
  18. Multicast Emulation shows empty results in Application Metrics when the scenario is created.